Most of the anti-collision wall formwork uses steel plate as the raw material, which has the advantages of firmness and durability, and is favored by the market. In the process of production, the electric welding machine is used for welding and forming, so our welding density also affects the quality of the mold. Our sizes and specifications are complete, and can also be customized according to the needs of customers. In general, they have made contributions to the road construction. When making the anti-collision wall formwork, it is not only affected by the mold, but also the cement proportion standard is one of the important factors. The mixed water should not be more or less, which will affect the hardness of the cement. The finished product we made should not only be smooth and beautiful, but also adapt to our outdoor climate, so that it can be used for a long time.
When the anti-collision wall formwork is assembled on site, the order of the steel panel shall be arranged according to the design drawings. The configuration of the gap and each component shall be guided by the design. We shall install it in the order from top to bottom. When the steel plate cannot use independent support, we shall use the temporary fixing method to ensure the safety of the steel plate The anti-collision wall mold is a stable whole, so when we use it, we should also pay attention to regular maintenance, and do not let it rust, which will affect the specification and size of the next mold prefabrication production. There will be some differences in the use of materials and connection methods for different length of anti-collision wall formwork. For example, the number of bottom tie rods on the anti-collision wall with a length of 1 meter is 1 respectively, and the number of bottom tie rods with a length of 2 meters is 2 respectively. The purpose of this is not to waste resources, but also to ensure the fixed degree of the formwork. Through long-term use, it can be found that the number of left and right screws is also different with the length. Because the concrete pressure on the left and right connections is large, it is necessary to increase the density of screw holes, so as to ensure that the mold will not break in long-term use.