The formwork of the anti-collision wall appears in the form of combination. The anti-collision guardrail is often divided into roadside and central ones. Different styles are customized according to the needs. The mold is the main tool for the production of the highway anti-collision guardrail, and its use is very convenient, simple and fast. Before use, check whether the mold is in good condition and flat to ensure that the anti-collision guardrail products produced are not unqualified due to mold problems. If they cannot be used normally, they waste raw materials and time. Clean the sludge on the mold after the inspection, because if there is sludge on the mold, the product quality will be affected, its firmness will be insufficient, the wear resistance will be reduced, and it will also have a great impact on the demoulding. Put the mold on the construction site to complete the installation. The two pieces of the road anti-collision wall mold should be connected up and down with the pull rod to prevent the mold from maintaining the original shape during the filling process, so that the road anti-collision wall produced is unqualified and the aesthetics is insufficient. The length of the road anti-collision wall formwork is generally one meter, so as to facilitate the handling and installation of workers. According to the specific construction situation, use screws to connect and install a suitable number of road square brick wall formwork. Next, the filling operation is carried out. When filling, the vibrating rod is inserted to prevent excessive gas in the raw materials, which leads to too many bubbles in the produced road anti-collision guardrail, the product is not solid enough, and the wear resistance is greatly reduced, which is not in the interests of the construction party. After the filling is completed, it can be dried naturally.
The process of making the anti-collision wall formwork requires the use of special manufacturing equipment, which requires that the manufacturer must have a full set of mold manufacturing equipment to ensure the production of the mold, which is the basic requirement of the manufacturer. During the production and production, the manufacturer also needs to use thickened materials, which can ensure the quality of the mold and ensure the smooth completion of the actual production and construction. The anti-collision guardrail steel template is a kind of mold product made by cutting, bending, welding and other processes of steel, because when steel is used for production and manufacturing, it needs to be assembled manually, unlike plastic mold, which is molded by injection molding. When the anti-collision guardrail template is purchased, the price and quantity are not too much related, Because this kind of mold has no cost of opening, whether it is a small amount of mold production or large-scale production, the price difference of each mold is very small, but if it is a large-scale production, it may be relatively large in terms of preferential strength, which depends on the quotation of each manufacturer. Our factory is specialized in the production of cast-in-place anti-collision wall steel mold manufacturers, with many years of experience, if necessary, you can consult us.