The mold of anti-collision guardrail is a kind of large production volume, because every regional highway can not do without the support of this template, so in order to make a better contribution in the market of steel mold for anti-collision wall, manufacturers need to innovate in the development of formwork, what are the specific contents? The use of plates shall prevail. Although the specifications and shapes of each set of formwork are the same, the unit price of the mould is different. This is because the thickness of the plate used and the density of the rib plate are different, which leads to the different weight of the mold. Therefore, the unit price is naturally different. It is necessary to select the appropriate steel plate according to the mold length and the requirements of the construction unit. The connection mode is mainly used. In the past, the connection between the two sets of anti-collision guardrail molds was mainly made of clasps, but it is easy to damage after a long time. Therefore, in order to ensure that there will be no connection errors and no leakage of concrete, the manufacturer has changed the way of tightening with screws, and the upper and lower fixing are all using pull rods, so that the thickness can be adjusted at will It can't be adjusted because it's fixed. Then the diversified development of anti-collision wall mold needs not only the innovation of mold manufacturers, but also the improvement of construction units of design drawings.
Safety should be put first in the construction of anti-collision guardrail mold. When such a large mold is constructed in the construction site, we should also pay attention to the personal safety hazards of the construction personnel. Therefore, we should wear the safety helmet and some safety tools to ensure the firmness, The safety rope on the body is also essential. These are important tools to prevent the installation of anti-collision guardrail mold. Some anti-collision guardrail mold is prevented at a higher place. From this point, we can see that the mold is everywhere, but when installing, we should build the protective fence according to the strict implementation requirements, and prohibit the upper and lower work at the same time